1. Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server?
2. A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is set as 5 days. An employee returns to the office after an absence of one week. When the employee boots the workstation, it sends a message to obtain an IP address. Which Layer 2 and Layer 3 destination addresses will the message contain?
3. Which is a DHCPv4 address allocation method that assigns IPv4 addresses for a limited lease period?
4. Which address does a DHCPv4 server target when sending a DHCPOFFER message to a client that makes an address request?
5. As a DHCPv4 client lease is about to expire, what is the message that the client sends the DHCP server?
6. What is an advantage of configuring a Cisco router as a relay agent?
7. An administrator issues the commands:
Router(config)# interface g0/1
Router(config-if)# ip address dhcp
What is the administrator trying to achieve?
8. Under which two circumstances would a router usually be configured as a DHCPv4 client? (Choose two.)
9. A company uses the SLAAC method to configure IPv6 addresses for the employee workstations. Which address will a client use as its default gateway?
10. A network administrator configures a router to send RA messages with M flag as 0 and O flag as 1. Which statement describes the effect of this configuration when a PC tries to configure its IPv6 address?
11. A company implements the stateless DHCPv6 method for configuring IPv6 addresses on employee workstations. After a workstation receives messages from multiple DHCPv6 servers to indicate their availability for DHCPv6 service, which message does it send to a server for configuration information?
12. An administrator wants to configure hosts to automatically assign IPv6 addresses to themselves by the use of Router Advertisement messages, but also to obtain the DNS server address from a DHCPv6 server. Which address assignment method should be configured?
13. How does an IPv6 client ensure that it has a unique address after it configures its IPv6 address using the SLAAC allocation method?
14. What is used in the EUI-64 process to create an IPv6 interface ID on an IPv6 enabled interface?
15. What two methods can be used to generate an interface ID by an IPv6 host that is using SLAAC? (Choose two.)
16. Refer to the exhibit. Based on the output that is shown, what kind of IPv6 addressing is being configured?
17. Refer to the exhibit. What should be done to allow PC-A to receive an IPv6 address from the DHCPv6 server?
18. Refer to the exhibit. A network administrator is implementing stateful DHCPv6 operation for the company. However, the clients are not using the prefix and prefix-length information that is configured in the DHCP pool. The administrator issues a show ipv6 interface command. What could be the cause of the problem?
19. Refer to the exhibit. A network administrator is implementing the stateless DHCPv6 operation for the company. Clients are configuring IPv6 addresses as expected. However, the clients are not getting the DNS server address and the domain name information configured in the DHCP pool. What could be the cause of the problem?
20. Fill in the blank. Do not abbreviate.
Type a command to exclude the first fifteen useable IP addresses from a DHCPv4 address pool of the network 10.0.15.0/24.
Router(config)# ip dhcp excluded-address 10.0.15.1 10.0.15.15
21. Order the steps of configuring a router as a DHCPv4 server. (Not all options are used.)
[+] Step 1 -> Exclude IP addresses.
– not scored –
22. Match the descriptions to the corresponding DHCPv6 sever type. (Not all options are used.)