Category: CCNA 3 v4

Q.1 In which VTP mode can a switch create VLANs, ignore VTP messages, and not pass local VLAN information to other VTP domain members?  Client  Server  Pruning  Transparent Q.2 What are two characteristics of an extended ACL? (Choose two.)  IP is used to specify TCP traffic only.  IP is used to specify TCP and UDP ...

Q.1 Refer to the exhibit. Based on the output shown, to which IP network should the workstations in the Support department belong?  192.168.1.0  172.16.1.0  172.16.3.0  172.16.5.0 Q.2 Refer to the exhibit. A network administrator is doing proactive network maintenance. The administrator pings 192.168.1.100 and compares the results to the baseline data. Based on the comparison ...

  Q.1 Refer to the exhibit. A network administrator needs to add the command deny ip 10.0.0.0 0.255.255.255 any log to R3. After adding the command, the administrator verifies the change using the show access-list command. What sequence number does the new entry have?  0  10, and all other items are shifted down to the ...

Q.1 Why are Network Control Protocols used in PPP?  to establish and terminate data links  to provide authentication capabilities to PPP  to manage network congestion and to allow quality testing of the link  to allow multiple Layer 3 protocols to operate over the same physical link Q.2 What is the data transmission rate for the ...

  Q.1 What three statements are true about routers that are configured for EIGRP? (Choose three.)  They can support multiple routed protocols.  They can support only link-state protocols.  They send their entire routing tables to neighboring routers.  They send partial routing updates in response to topology changes.  They send routing updates to all other routers ...

Q.1 Refer to the exhibit. What statement describes the DR/BDR relationship of the HQ router?  HQ is the DR.  HQ is the BDR.  HQ is a DROTHER.  HQ is a member of an NBMA network. Q.2 Which two features are associated with Frame Relay OSPF point-to-multipoint environments? (Choose two.)  A DR is not elected.  The ...

Q.1 A network engineer is implementing a network design using VLSM for network 192.168.1.0/24. After subnetting the network, the engineer has decided to take one of the subnets, 192.168.1.16/28 and subnet it further to provide for point-to-point serial link addresses. What is the maximum number of subnets that can be created from the 192.168.1.16/28 subnet ...

Q.1 Refer to the exhibit. What two statements can be concluded from the information that is shown in the exhibit? (Choose two.) All ports that are listed in the exhibit are access ports. ARP requests from Host1 will be forwarded to Host2. Attaching Host1 to port 3 will automatically allow communication between both hosts. The ...

Q.1 What type of connection point is a point of presence (POP)?  between a client and a host  between two local networks  between a computer and a switch  between an ISP and an Enterprise network Q.2 A network administrator needs to configure Telnet access to a router. Which group of commandsenable Telnet access to the ...

  Q.1 What can be found at the enterprise edge?  Internet, VPN, and WAN modules  Internet, PSTN, and WAN services  server farms and network management  campus infrastructure, including access layer devices Q.2 In which functional area of the Cisco Enterprise Architecture should IDS and IPS be located to detect and prevent services from accessing hosts? ...